![]() Apply your glitter, foil or flocking to complete your sentiment.Peel off the backing paper carefully – try not to crease or bend your sentiment.Practice with bolder words and font styles. Even though the cut goes all the way through, you can find the material is a little tricky to weed.Cut your design using a full cut to make it easier to weed.Place your material so the double-sided adhesive side (with backing sheet) is face down to the mat.Apply your adhesive to the front of your card.Transfer to your machine or proceed to cut if you are using your built-in designs.Flip the design back to front as we will be cutting from the back of your material.Weld it into one piece so it is easy to remove from the backing sheet.Start by creating your desired sentiment using a bold script font of your choosing.Intricate design and glitter application: Use your normal automatic settings or adjust your blade half a mark deeper. Cutting settingsīasic designs and stickers: Use the same settings as for your material normally, or use half cut on your ScanNCut DX to keep your backing paper intact. Leave the backing paper attached for both purposes and load your media protective paper down to the sticky of your mat. Cut backwards to use the adhesive for glitter, foil, flock and embossing powder applicationįor uses 1-4, apply your adhesive to the back of your card without overlapping it won’t hurt too much should there be any small gaps.įor use 5, apply the tape to the front of the card, but ensure there are no gaps or overlaps to have a neat finish for your glitter or other finishing media.For designs where you need to use transfer paper for accurate application.For intricate designs for easy application.To create your own cardstock sticker material. ![]()
0 Comments
Leave a Reply. |